Airless Sprayer - Pressure: 2000 PSI Tip.Shorter nap performs better when applying Hemp Shield™. Roller - Use 1/8" to 3/8" nap synthetic roller cover.Brush - Use a nylon/polyester bristle brush or foam brush.
Let the wood tell you how much Hemp Shield™ to use.Īpplication Method Specifications & Other Information: This is determined by species, porosity, cell structure, rate of growth, weathering, age, and other factors such as ambient moisture. Different types of wood will accept varying amounts of Hemp Shield™.
Hemp Shield's protection is in the wood - it creates a much thinner surface film tham conventional finishes, Any excess material remaining on the surface at this point should be dry-brushed, dry-rolled, or wiped with an absorbent cloth. Immediately after application, Hemp Shield™ may appear slightly milky, but it will quickly become clear as it penetrates. Hemp Shield™ should be applied continuously from one end of a plank to the other.When using Hemp Shield™, it is important not to over-apply, as excess material, if allowed to remain, can cause slow, uneven drying, discoloration, sticky residue, and peeling.Instead of forming a urethane or acrylic shell over the wood's exterior, the hybrid waterborne hemp oil in Hemp Shield™ penetrates the wood, working from within to protect and nourish your outdoor wood. Hemp Shield Deck Sealer and Wood Finish™ works very differently from other outdoor wood protectants.Once the Hemp Shield has cleared, remove any excess material with a rag, dry brush, or roller. During application, Hemp Shield will appear milky, but will clear as it penetrates. Do not over-apply - excess material can cause uneven drying, discoloration, surface residue, and peeling.Use at package consistency - do not thin.Do not apply to any surface that feels wet to the touch.A very light misting of water, just enough to tighten the grain on the surface, will also reduce any lapping tendencies. All water based decking stains have a potential to lap to reduce lapping tendencies, do not apply in direct sunlight or when the wood feels hot to the touch.Do not apply to new or restored wood if the moisture content exceeds 15% or the surface is wet to the touch.Relative humidity should not exceed 85%.Apply when the temperature (surface, product, and air) is between 50☏ (10☌) minimum, 100☏ (37☌) maximum, and at least 5° above the dew point.Avoid applying late in the day, when dew or condensation is likely to form, or when rain is threatening.Hemp Shield™ can be applied by brush, roller, foam brush, and airless or conventional sprayers.To use Hemp Shield on wood that retains a coat of the previous finish it may be necessary to remove the existing finish with blast media such as walnut shells, dry ice, or other media.These previous finishes will prevent Hemp Shield from working since it cannot penetrate into the wood. We do not recommend applying Hemp Shield to wood where a glossy finish remains.Previously stained or weathered wood surfaces must be sanded, scrubbed, or otherwise treated to remove loose wood fibers, dirt, mildew, chalky residues, waxes, oils from exotic and pressure treated wood, shiny new wood (Mill Scale) and other foreign materials.Wood moisture content must be below 15% (approximately the same as kiln dried lumber) or the surface must be exposed to dry weather for 3 to 5 days before applying Hemp Shield™.Surfaces must be structurally sound and completely dry.
#WEB SHIELD SHOULD I REMOVE IT FREE#
0 kommentar(er)
